Aesthetix Janus Signature Preamplifier

Code: AEST-JANUS-SIG
  • £14,330.00
  • (FREE UK Delivery)
| Usually dispatched within 24 hours
Loading...

The Signature version uses custom-made inter-stage Teflon hybrid coupling capacitors, replacing the polypropylene units, between the gain stage and output stage (2 per channel). The change in these capacitors results in higher resolution, extension, less grain and more air. The 2uF output coupling capacitors (4 per channel) are replaced with 4uF Dynamicaps. This change provides more drive, bass extension, resolution and dynamics while also reducing grain.

Key Features:

  • Fully balanced differential line-level circuitry with ability to internally balance a single ended input signal.
  • RCA and XLR provided for each input.
  • Discrete resistor volume control with 88 1dB steps.
  • Zero feedback.
  • Phono input: 40-75dB gain maximum, selectable via front panel or remote control.
  • Built-in MC cartridge demagnetizer.
  • 9 MC loading settings: 75-47,000 ohms, selectable via front panel or remote control.
  • All tube amplification and output (12 tubes total).
  • Two sets of XLR and two sets of RCA outputs per channel.
  • Bypass mode for home theatre processor throughput.
  • Absolute phase, selectable via front panel or remote control.
  • Full function remote included.
  • Available in black or silver faceplate.

For the phono section, the Signature Version uses custom-made inter-stage Teflon hybrid coupling capacitors, replacing the polypropylene units, between the 2nd and 3rd gain stages(2 total per channel). The change in these capacitors results in higher resolution, extension, less grain and more air.

The 2uF output coupling capacitors that drive the line section (2 per channel) are replaced with 4uF Dynamicaps. This change provides more drive, bass extension, resolution and dynamics while also reducing grain.

Highly specialized adjustable air-core capacitors, used primarily in the radio-frequency realm, are installed and adjusted to "tweek" each unit to a rigid standard.

The five rubber feet are replaced with Harmonic Resolutions Systems' Nimbus Couplers specially made for Aesthetix (Earlier Signature Saturn pieces did not incorporate this, please contact Aesthetix for this free upgrade if you have an earlier Signature piece without the Nimbus Couplers). This change results in a lower noise floor and more air and space.

The cost of these specialized parts alone is about 1/4 the manufacturing cost of a brand new unit! Any tubes that can be bettered by our special stock of graded and matched tubes are replaced. Any other improvements needed to make the unit current are installed, including software updates, etc.

A new lens with "SIGNATURE" stenciled is installed. Each Signature unit undergoes rigorous test procedures and listening.

Technical Specifications:

  • Inputs: 1 phono RCA (SE), 5 line RCA or XLR (balanced), plus 1 tape, RCA or XLR
  • Outputs: 2 RCA (SE) and XLR (balanced), 1 tape RCA
  • Phono gain settings: 8 total; 75, 68, 62, 56, 50, 44, 38 dB, and off
  • Phono load settings: 9 total; 47 K ohms, 10K, 5K, 2.5K, 1K, 500 ohms, 250, 125, and 75 ohms
  • Line level gain: 23 dB single ended (SE), in/out, and 29 dB balanced/out
  • Volume control: switched resistor network volume control with 88 1 dB steps
  • Front panel controls: main input, tape input select, volume, balance, phase, mute, display, bypass and standby
  • Remote controls: main input, tape input select, volume, balance, phase, mute, display, phono gain and loading, demagnetizer, bypass and standby
  • Frequency response: +- 0.25 dB, 20 Hz - 20 Khz
  • Signal to noise: measured at 70 dB minimum A-weighted (ref 1 mv input, 75 dB gain setting)
  • Line input impedence: 40 k ohms SE, 80 k ohms balanced
  • Maximum line input: 3.5 volts SE, 7.0 volts RMS balanced
  • Output impedence: 1K ohms SE, 600 ohms balanced
  • Recommended load: 10K ohms or greater (SE), 20K ohms or greater (Balanced)
  • Tubes, each channel: phono section: V1 & V2 (12AX7-factory graded low noise), V3 (12AX7), V4 (6922/6DJ8); line section: V1 (12AX7 or equivalent), V2 (6922/6DJ8)
  • Power consumption: 20 watts standby, 120 watts active
  • Physical dimensions: 4 3/8" high, 17 7/8" wide, 18" deep including jacks
  • Shipping weight: 40 lbs.

We endeavour to despatch same day for orders placed up to 12 noon on available stock items (items with stock message "Usually dispatched within 24 hours"). Please remember to check with us first for a physical stock check if next day delivery is important to you. Any items with stock message "Usually dispatched within 72 hours" are items that we do not hold in stock but order in from the importer or manufacturer as soon as a customer order is recieved. Occasionally these may be delayed beyond 72 hours due to importer/manufacturer stock levels but we will inform you as soon as we can if this is the case.

UK ORDERS:  We despatch the bulk of our UK mainland items on a 24 hour service – Free of Charge.  Non Mainland locations - Isle of Man, Isle of Wight, the Scilly Isles, the Scottish highlands and Islands, the Channel Islands and Northern Ireland may take a day or so longer and are not Free of Charge. Smaller items are delivered using Royal Mail recorded delivery or special delivery. Larger items are delivered using a courier service such as Interlink Express, DPD, UPS or DHL. 

INTERNATIONAL ORDERS: We offer competitive rates which can be confirmed by email. Please just ask – we will need a full delivery address and telephone number. Smaller items are delivered using Royal Mail Small Packets Airmail with International Tracked and/or Signed depending on value of item and availability of the service. Larger International shipments are sent by insured and tracked services using DPD, DHL or UPS. If there are any delays due to specific customs regulations, etc, you will be contacted by Turntableworld or by the courier with a request for any further information required. Customs duties do not apply for shipments into any EU country (for a full list please refer to the EU Country List). Customs duties can apply for countries outside of the EU. Customers in these countries are responsible for all taxes and duties incurred when the items enter their country.

COLLECT IN STORE OR HOME INSTALL:At the request of the manufacturer some items cannot be supplied by mail order but you can click and buy them and then elect to collect them from our store or arrange a home install (if applicable). Applicable items clearly state that they are Collect in store or home install. Once ordered you will receive a message prompting you to contact us by phone or email to arrange for us to deliver and install or to reserve and collect from our store at your convenience, you will also be advised of the delivery time / stock availability as not all Home install / collect in store items are held in stock. 

Be the first to review Janus Signature Preamplifier. Write a review ›
Top